Sativa 71 Hyaluronic Acid Eye Serum Correction of Wrinkles and Moisturizing 20ml / 0.67oz

All Skin Types High- & Low-molecular Hyaluronic Acid
Moisturizes durably • Strengthens skin elastin-collagen lattice • Activates the synthesis of hyaluronic acid
 
Gel-serum to restore and protect delicate eyelid skin from premature ageing. A complex of low-molecular hyaluronic acid and anti-ageing active ingredients restores the collagen lattice and reduces wrinkles. Also stimulates the synthesis of its own hyaluronic acid. Antioxidant complex provides neutralization of free radicals, increases resistance to urban smog, and prevents premature skin ageing.
INCI:
Aqua, Rosa Damascena Flower Water, Glycerin, Hydrolyzed Olive Fruit, Hydrolyzed Beta-Glucan, Lonicera Caprifolium (Honeysuckle) Flower Extract (and) Lonicera Japonica (Honeysuckle) Flower Extract, Disodium Acetyl Glucosamine Phosphate, Sodium Hyaluronate, Acacia Senegal Gum (and) Xanthan Gum, Gluconolactone, Sodium Hyaluronate (low-molecular).
Apply a small amount of the serum to cleansed skin in the bone area under the eyebrow, as well as on the lower eyelid, avoiding contact with the mucous membrane. Gently massage the serum from the inner corner to the outer corner of the upper eyelid and from the outer corner to the inner - lower eyelid. Use the serum in the morning and in the evening.
Can be used as a standalone product.
For extra moisturizing, apply the serum under the care cream.
As a base for makeup, put the serum 15-20 minutes before applying decorative cosmetics.
Apply the serum 20-30 minutes before bedtime and at least 30 minutes before going outside during the cold season.
When you first receive your airless pump bottle, pump the top a few times and your product should start dispensing normally. Some bottles may take up to 10-30 pumps.  If you’re not getting any product after pumps, we recommend priming the pump. There is a disk that pushes the product to the top which can become stuck, and you may need to bang the bottom of the bottle 3-4 times on a flat-hard surface to loosen the disk, then hold your bottle upside-down and gently tap the top of the bottle against a flat surface. This should get the product moving. 
When you first receive your airless pump bottle, pump the top a few times and your product should start dispensing normally. Some bottles may take up to 10-30 pumps.  If you’re not getting any product after pumps, we recommend priming the pump. There is a disk that pushes the product to the top which can become stuck, and you may need to bang the bottom of the bottle 3-4 times on a flat-hard surface to loosen the disk, then hold your bottle upside-down and gently tap the top of the bottle against a flat surface. This should get the product moving.