BTpeel Green peeling biorevitalizant with peptides, lactobionic acid and nettle extract (two-phase) 10ml

BTpeel, an innovative green, two-phase peel with biostimulating, revitalizing, and exfoliating properties, promotes cell renewal by removing cells from the upper layers of the epidermis, selectively targeting corneocyte connective tissue. The targeted action of the active ingredients promotes deep stimulation, revitalization of the dermis, and acceleration of biosynthetic processes necessary to counteract the effects of skin aging and oxidative damage caused by UV radiation.
Benefits of green peeling:

A revolutionary amount of active ingredients
No frost effect
15-minute procedure
Instant results
Multifunctional
No downtime
Painless
All-season
Natural biological composition
Suitable for all ages
Special patented two-phase formula
BTpeel green peeling can be used for the following skin conditions:

Signs of photo- and chronoaging
Dry and dehydrated skin
Active acne (stages 1-2)
Post-acne (atrophic scars, hyperpigmentation, stagnant spots)
Enlarged pores
High sebum secretion
Hyperpigmentation of various origins
Dull skin
Fine wrinkles

Ingredients: Malic acid, Pyruvic acid, Citric acid, Ascorbic acid, Lactobionic acid Acid, Peptide Complex, Nettle Extract.

PH: 2.1

Directions for use: Cleanse skin with BTreeel Cleansing Gel with Lemon Extract and Hyaluronic Acid, then pat dry with a paper towel. Wipe skin with a cotton pad soaked in BTreeel Exfoliating Emulsion with Glycolic Acid. Wait until the emulsion is completely absorbed or pat dry with a paper towel. You can use any alcohol-based solution instead of the Exfoliating Emulsion. Shake the peeling solution bottle for a few seconds until a short, uniform green emulsion forms. The two different colored peeling phases should mix. Dispense the required amount of the peeling solution into a prepared glass container or syringe without a needle. Close the bottle; do not leave it open for long periods of time. Apply the solution to the skin using a syringe (without the needle) or simply your fingers, gently massaging the solution into the skin until completely absorbed. Leave it on for 3 to 10 minutes, depending on your skin type and individual characteristics. Up to 4 layers of peel can be applied, waiting 1-2 minutes between layers. The procedure ends with a persistent tingling or slight burning sensation combined with skin erythema. To complete the peeling process, rinse thoroughly with cool water. Blot any remaining moisture with a paper towel. To stimulate repair and hydration processes and relieve discomfort, we recommend applying a mask: BTpeel Moisturizing Stimulating Mask with Rose Extract and Beeswax, BTreel Lamellar Nourishing Mask "Three Oils" with Herbal Extract and Prebiotic, or BTpeel Moisturizing Cleansing Gel Mask with Peptides. Apply a medium layer of each mask. The exposure time is 15-25 minutes. After this, rinse off the mask with water and dry the skin with a paper towel. Apply BTpeel sunscreen to the skin. Post-peel care: Active skin cell renewal occurs for 1-3 days after the procedure. During this period, be sure to use sunscreens (at least SPF-40), for example, BTpeel Sunscreen Regenerating Cream with Carrot Extract SPF-40 UVA/UVB/PA++++ or BTpeel Sunscreen Moisturizing Cream for Oily and Combination Skin SPF-50 UVA/UVB/PA++++. During this period, it is necessary to actively use moisturizing creams and masks. Wash your face with clean water. During periods of sun exposure, it is recommended to apply SPF every 2.5-3 hours.